One moment please while we configure Electro-Voice.com for you...
Electro-Voice.com

Welcome to Electro-Voice.com. Please specify your country so we can customize your experience.

The Americas
amer
Asia & the Pacific Rim
apr
Europe,
the Middle East, & Africa
emea
cn
lam
Access to this file requires a registered account. Log in or use the link below to register an account.
  • Home
  • Mics
Accessories needed for wireless microphone antenna systems. Included are products for remote mounting, amplifying, distributing and combining antenna signals.
Compare Specifications

Knowledgebase

Contact Support

Tel: (866) 782-8346

More Support Resources

AB-2
The AB-2 is a universal mounting bracket for use with FA-XX and CLA-X ground-independent half-wave antennas. Includes 10-foot coax cable.
AN-Sflex
Quarter-wave super flex antenna for REV-WT, WTU-2, and older CSB-1000, WT-1000, and REV-BP bodypacks.
APD-4+
The APD4+ is a UHF antenna/power distribution system  for use with RE-2 and REV receivers, providing power and RF signals for 4 units.
CXU-X
The CXU is a family of low-loss coaxial cables for longer antenna cable runs. Pre-cut in lengths of  25 ft (8 m), 50 ft (16 m), 75 ft (23 m), and 100 ft (30.6 m). “XXX” designates length in feet.
FA-XX
The FA-XX is a family of ground independent half-wave omni-directional antennas. These antennas can be remote mounted using the AB-2 bracket or attached directly to a receiver or an APD4+.
FMCK
The FMCK includes four front-mount antenna cables with female TNC connectors on one end and a bulkhead male TNC on the other end. The male connectors mount in the provided knockouts of the RM-S and RM-D rack mount kits. The four included cables are enough for two receivers.
LPA-500
The LPA-500 is a passive directional log periodic antenna that is used to extend the range of coverage in given direction. It comes with mounting hardware and 10-foot coax cable.
TP-2
50 Ω TNC termination plug for use with APD4+ antenna distributor.  All unused outputs of the APD4+ must be terminated to prevent reflections and range problems.
UAA-500
The UAA-500 is a broadband UHF amplifier with selectable 3dB and 10dB amplification settings.  Antenna signal amplifiers are used to make up for losses in the cable run, they do not extend the operating range of the wireless microphone.